Color Change with Temperature 3D Printer Filament PLA Sublimation Plastic Chameleon 3D Printing Material 1.75mm 1kg/500g/250g

Color Change with Temperature 3D Printer Filament PLA Sublimation Plastic Chameleon 3D Printing Material 1.75mm 1kg/500g/250g

Glittering PLA 3D Printer Filament Blue Black Red Grey 1.75mm 1kg/500g/250g Sparkle Shining 3D Printing Sublimation Material

Temperature Change Color Filament Introduction:

A. Temperature Change Color Filament is one type of color change filament, by mixing some Temperature changing color powder inside PLA.

B. PLA Temperature Change Color is a material will change color from one color to another color when exposed to a temperature of 33°C or higher. Even holding the part in your hand for a few moments will be enough to start the color transformation. Once the parts cools back down to room temperature, the color will go back to the original color.

C. This Temperature Change Color PLA is the same PLA as our standard PLA but with an included additive that will make your 3D printed object actually change color! Print settings are the same as standard PLA .

D. Suitable for assorted 3D printer, For Easy threed, For Makerbot, For UP, For Luzbot, For Leapfrog, For Reprap, For Ultimaker, For Mendel, For Prusa, For Raise3D , etc.

Note:

The filaments are all vacuum packaged, but the vacuum packaging may enter some air after being squeezed by other packages for long-distance transportation, this case it will not affect the normal use of the filament. (There is a desiccant in the vacuum package that can absorb water in the air ).

Temperature Change Color Type:

Color: Brown to Green , Purple blue To pink , Green to Yellow

Brown Green -> Green (> 31℃)

Purple Blue -> Pink (> 33℃)

Green -> Yellow (> 33℃)

Temperature Change Color Specification:

1. Material: Temperature Change Color Filament

2. Critical Temperature: Around 31 degree centigrade

3. Color: 3 colors change and 2 color changes

4. Filament Diameter: 1.75mm

5. Tolerance: ±0.05mm

6. Print Temperature: 190~230℃

7. Infill Speed: 20-50mm/s

8. Heat-Bed Temperature:Not required but can be used(up to 50°C)

9. Density: 1.25±0.05g/cm3