Color Changing with Temperature PLA 3D Printer Filament 1.75mm 500g/250g Gradient Thermochromic Sublimation Printing Material

Color Changing with Temperature PLA 3D Printer Filament 1.75mm 500g/250g Gradient Thermochromic Sublimation Printing Material

Temperature Change Color Filament Introduction:
A. Temperature Change Color Filament is one type of color change filament, by mixing some Temperature changing color powder inside PLA. 
B. PLA Temperature Change Color is a material will change color from one color to another color when exposed to a temperature of 33°C or higher. Even holding the part in your hand for a few moments will be enough to start the color transformation. Once the parts cools back down to room temperature, the color will go back to the original color.
C. This Temperature Change Color PLA is the same PLA as our standard PLA but with an included additive that will make your 3D printed object actually change color! Print settings are the same as standard PLA . 
D. Suitable for assorted 3D printer, For Easy threed, For Makerbot, For UP, For Luzbot, For Leapfrog, For Reprap, For Ultimaker, For Mendel, For Prusa, For Raise3D , etc.

Note:
The filaments are all vacuum packaged, but the vacuum packaging may enter some air after being squeezed by other packages for long-distance transportation, this case it will not affect the normal use of the filament. (There is a desiccant in the vacuum package that can absorb water in the air ).

Temperature Change Color Type:
Color: Orange to Yellow, Brown to Green , Purple blue To pink , Green to Yellow 
Orange -> Yellow (> 31℃) 
Brown Green -> Green (> 31℃) 
Purple Blue  ->  Pink (> 33℃)
Green -> Yellow (> 33℃)

Temperature Change Color Specification:
1.    Material: Temperature Change Color Filament
2.    Critical Temperature: Around 31 degree centigrade
3.    Color: 3 colors change and 2 color changes
4.    Filament Diameter: 1.75mm
5.    Tolerance: ±0.05mm
6.    Print Temperature: 190~230℃
7.    Infill Speed: 20-50mm/s
8.    Heat-Bed Temperature:Not required but can be used(up to 50°C)
9.    Density: 1.25±0.05g/cm3